Accomplishments: This week I used a router table to to shave off the edges of our guitar. We used two cuts to get the most round of an edge that we could. Then, using 220 sand paper to remove any burn marks and lines that may have formed from the router table. I also started the process of putting dot inlays on my fingerboard. We measured where the dots will by by finding the middle of certain frets and put a small hole to mark the smart
Tools: Router table, sand paper, ruler, the tool we use to mark a hole in and will later use to drill the hole for when we put in the dots
Learned: when using a router table you want to go against the way the blade is to get a nice cut. There are only dot inlays on frets 3, 5, 7, 9, two on 12, 15, 17, 19, and 21
Lauren's Guitar Build 